ela
Contents

ManualShell

Jobs at the prompt

In the terminalela --spec jobs-at-the-prompt

A job started at the prompt belongs to the session, so the prompt comes back at once and the job runs on while other lines are typed (LANGUAGE.md, Who waits). A job started in a proc or a with block is still that code's, which waits for it.

ela> x = run make testela> git status...run: x ✓ make test 2:15 — wait $x to see its outputela> wait $x
  • When a job has ended, a line says so before the next prompt: the variable holding it, ✓, or ✗ and its exit code, the command or the call, and the time it ran. A job held in a list or a map gets its number instead; its output stays held until it is waited for.
  • A job no variable holds can never be waited for, so its output follows its line.
  • A job's output is held until wait, which prints it whole; $x.output reads it once the job has ended.
  • Ctrl-C while wait waits ends the wait, not the job, and returns to the prompt.
  • exit, or Ctrl-D, with jobs still running or stopped says how many, 2 jobs running; exit again to stop them, 1 job stopped; exit again to end it, or 2 jobs running and 1 stopped; exit again to end them, and stays. A second exit straight after sends them TERM, and a stopped one CONT after it so it ends, then KILL to those still there 3 seconds later, and leaves; any other line in between asks again at the next.
  • catch run works in scripts only.